-
Recent Posts
- Repairing a Ridgeflow Conservatory Vent Fan
- Piper Autocontrol III Wing Leveller Fault Finding
- Home Energy Management System Part 4: Characterising the Hypervolt Current Transformer
- Home Energy Management System Part 3: Planning the hardware
- Home Energy Management System Part 2: Hacking the iBoost+ protocol
Recent Comments
Bill quintal on Alternator failure warning in… Sam on Home Energy Management System… Steve on Home Energy Management System… Warren Daniel on Troubleshooting old Century… Charlton on Troubleshooting old Century… Archives
Categories
Meta
Monthly Archives: January 2015
Upgrading the Mini Kossel to Duet Electronics Part 3: Calibration
In the third part of this mini-series, I will cover final commissioning of the Mini Kossel with Duet electronics.
Upgrading the Mini Kossel to Duet Electronics Part 2: Software and Commissioning
In Part 1 of this two-part series, I covered the hardware changes needed to use Duet electronics with the Mini Kossel in place of Arduino/RAMPS electronics. In this second part, I will cover installing the software and the first stages … Continue reading
Upgrading the Mini Kossel to Duet Electronics Part 1: Hardware
The Mini Kossel delta 3D printer is available in kit form from various suppliers, including Think3DPrint3d (T3P3) in the UK. The kits currently supplied by TPT3 include an Arduino Mega and a RAMPS board to control the printer with Marlin firmware. Although this combination … Continue reading