-
Recent Posts
- Home Energy Management System Part 4: Characterising the Hypervolt Current Transformer
- Home Energy Management System Part 3: Planning the hardware
- Home Energy Management System Part 2: Hacking the iBoost+ protocol
- Home Energy Management System Part 1: Objectives
- Adding filament monitors to the Hemera tools
Recent Comments
Bill quintal on Alternator failure warning in… Sam on Home Energy Management System… Steve on Home Energy Management System… Warren Daniel on Troubleshooting old Century… Charlton on Troubleshooting old Century… Archives
Categories
Meta
Tag Archives: Mini Kossel
Upgrading the Mini Kossel to Duet Electronics Part 3: Calibration
In the third part of this mini-series, I will cover final commissioning of the Mini Kossel with Duet electronics.
Upgrading the Mini Kossel to Duet Electronics Part 2: Software and Commissioning
In Part 1 of this two-part series, I covered the hardware changes needed to use Duet electronics with the Mini Kossel in place of Arduino/RAMPS electronics. In this second part, I will cover installing the software and the first stages … Continue reading
Upgrading the Mini Kossel to Duet Electronics Part 1: Hardware
The Mini Kossel delta 3D printer is available in kit form from various suppliers, including Think3DPrint3d (T3P3) in the UK. The kits currently supplied by TPT3 include an Arduino Mega and a RAMPS board to control the printer with Marlin firmware. Although this combination … Continue reading
Ormerod and Mini Kossel 3D printer kits compared
I’ve now built two 3D printers from kits: first an Ormerod both designed and supplied in kit form by RepRapPro, and more recently a Mini Kossel designed by Johann Rocholl and supplied in kit form by Think3dPrint3d. So here is a comparison of … Continue reading